🧪 SciSim.co.uk

Refraction of Light

IGCSE Physics — Investigate how light bends when passing between materials

Simulation

Click or drag on the top half to change the angle of incidence

Controls

Angle of Incidence (θ₁) 30.0°
Angle of Refraction (θ₂) 19.2°
n₁ 1.00
n₂ 1.52
n₁ sin θ₁ 0.500
n₂ sin θ₂ 0.500
Wavelength 580 nm
⚠ Total Internal Reflection! The angle of incidence exceeds the critical angle.

Key Concepts

Snell's Law: n₁ sin θ₁ = n₂ sin θ₂ — When light passes from one medium to another, the relationship between the angles and refractive indices is constant.

Refraction: Light bends towards the normal when entering a denser medium (higher n) and away from the normal when entering a less dense medium (lower n).

Total Internal Reflection: When light travels from a denser to a less dense medium, there is a critical angle above which all light is reflected back. This only occurs when n₁ > n₂.

Dispersion: The refractive index of a material depends on the wavelength (colour) of light. Violet light (short wavelength) is refracted more than red light (long wavelength). This is why a prism splits white light into a spectrum — each colour bends by a different amount.

Investigate refraction

Set the two materials and change the incident angle. Measure angles from the normal, the line perpendicular to the boundary, not from the surface. When light enters a material with a larger refractive index, it slows and bends towards the normal. When it enters one with a smaller refractive index, it bends away.

  1. Start with light travelling from air into a transparent material. Change the incident angle and compare it with the refracted angle.
  2. Reverse the direction from a higher-index material to a lower-index material. Increase the angle until a refracted ray no longer appears.
  3. Change the light colour. Compare the small changes in bending due to dispersion.

Use Snell's law

The relationship is n₁ sin θ₁ = n₂ sin θ₂. Total internal reflection is possible only when light travels from higher to lower refractive index and the incident angle exceeds the critical angle. At the critical angle, the refracted ray travels along the boundary. The model uses an ideal flat boundary and representative wavelength-dependent indices; rough surfaces, absorption and complex materials are not represented.

Check your understanding: Why can light going from glass into air show total internal reflection, but light going from air into glass cannot?