🧪 SciSim.co.uk

⚗️ Reaction Rates Simulation

IGCSE Chemistry - Investigating Factors Affecting Reaction Rate

Experiment Controls

Temperature 25°C

Higher temperature increases particle kinetic energy and collision frequency

Concentration (Acid) 1.0M

Higher concentration increases number of acid particles available

Surface Area

Smaller particles expose more surface area for reactions

Export Results

Ready to start experiment

Particle Collision Simulation

🔴 Red = Marble (limiting reagent) | 🔵 Blue = Acid (excess) | 💨 White = CO₂ gas

🟢 Green flash = successful reaction | 🟠 Orange flash = insufficient activation energy

Gas Volume vs Time

Real-time plot of reaction progress

Live Data

Reaction Rate
0.0 cm³/s
Total Collisions
0
Successful Reactions
0
Total Gas Volume
0 cm³
Temperature
25°C
Concentration
1.0M
Elapsed Time
0s

Key Concepts: Collision Theory & Reaction Rates

Collision Theory

Reactions occur when reactant particles collide with sufficient energy (greater than activation energy). Not every collision leads to a reaction — watch for the colour flashes: green = successful reaction, orange = unsuccessful (not enough energy).

Activation Energy

The minimum energy particles need to react on collision. At low temperatures, most collisions are unsuccessful because particles move slowly. At higher temperatures, a greater proportion of particles have energy exceeding the activation energy, so more collisions are successful.

Effect of Temperature

Increasing temperature gives particles more kinetic energy, causing them to move faster. This increases both collision frequency AND the proportion of collisions with energy ≥ activation energy, significantly speeding up the reaction.

Effect of Concentration

Higher concentration means more reactant particles per unit volume. This increases the likelihood of collisions occurring, resulting in a faster reaction rate. The particles have higher average kinetic energy.

Effect of Surface Area

For solid reactants like marble chips, smaller particle size increases total surface area. More surface is exposed for collisions, allowing more of the solid to react simultaneously with the acid, increasing reaction rate.

Effect of Catalyst

A catalyst lowers the activation energy required for a reaction without being consumed. This means more collisions have sufficient energy to cause a reaction, increasing the reaction rate without changing the temperature.

Investigate reaction rate

Use the controls to change the reacting conditions, then observe particle collisions and the gas-volume graph. A reaction occurs when particles collide with enough energy and a suitable orientation. The rate is the change in measured quantity per unit time, so a steeper gas-volume curve means a faster reaction at that moment.

  1. Run a baseline reaction and record the time taken to reach a chosen gas volume.
  2. Reset and change only one factor, such as concentration or solid surface area. Compare the early slopes and the final gas volume.
  3. Repeat with a catalyst. Explain the change using the activation-energy barrier, and note whether the amount of limiting reactant changed.

Design a fair test

Powder exposes more surface area than large chunks of the same solid, increasing collision frequency. Higher temperature increases average kinetic energy and the fraction of collisions above activation energy. A catalyst provides a lower-energy pathway. In a real gas-collection experiment, keep reactant amounts and apparatus constant, seal the bung promptly, repeat trials and report an average. The particle animation simplifies molecular orientation, heat transfer and side reactions.

Check your understanding: Why might two runs have different initial rates but the same final gas volume?